- 30 -
Wireless charging system 600W specication
For 12V・24V・48V battery
B&PLUS K.K.
〒 355-0311
2452-5 Koya Ogawa-machi Hiki-gun
Saitama JAPAN
TEL 0493-71-5160
FAX 0493-81-4771
HP https://www.b-plus-kk.jp/
E-MAIL sales@b-plus-kk.jp
Wireless Power Supply by
Phenomenon
Possible factors and remedies, etc.
When using the write cable (RCS RCS-DATA-CBL), the software
seems to be communicating, but the screen shows The message
“CONNECTING...” remains on the screen, butit does not become
OK after a while.
Please close the open software and plug/unplug the USB connec
-
tor side. After that, start up the software again.
Other ＜ Abnormalities in the battery ＞ When using two batteries in series, fully charge each battery to
the same voltage before installing the equipment. When using
two batteries in series, fully charge each one to the same voltage
before installing the equipment. If there is a voltage dierence, the
charging unit may fail. If you operate the product with a voltage
dierence, it may cause an error in the charging unit. If there is a
voltage dierence between the charging unit and the power supply
unit, it may cause an error in the charging unit. If there is a voltage
dierence between the charging unit and the power supply unit,
the two units will be synchronized, and the error will occur in both
units.
One of the reasons why some abnormalities may occur even though the product is operated within the specications is that
the customer's operating environment such as below may be the cause of the problem.
・the battery is not charged enough (in time) for the power consumption.
・Power supply voltage
・Environmental noise
・Surrounding metal
Check the LED lighting status and the condition in which the abnormality occurs (transmission distance, ambient temperature, etc.),
and consult with our sales representative.
11.Consultation on how to use and repair
To Next Page
Loading...