NanoRam
®
Series Handheld Raman
19 Shea Way, Newark, DE 19713, USA • Tel: +1 (302) 368-7824 • Fax: +1 (302) 368-7830 • Web: www.bwtek.com
290020255-J (2017/07/28) Page 16 of 38 Copyright 2017 B&W Tek
will facilitate easy and fast sampling. Depending on the type and form of the materials to be
measured, the appropriate sampling accessory can be selected. The sample can be placed
directly against the adaptor.
Liquid vial holder adaptor that
holds a 15mm(diameter)x 45mm(height) vial
Bottle adaptor for measurement through
a container
Calibration cap with built-in polystyrene
Right angle adaptor (optional)
Tablet holder adaptor (optional)
Immersion probe adaptor (for use with
NanoRam only)
The user needs to ensure that the sampling adaptor is installed properly before using the
NanoRam. Before installing any accessories the NanoRam should be at the log in screen
with the laser turned off to ensure safety. No operations are permitted without the lensed
shaft in full installed position with standard accessories, or an immersion probe, tablet
holder or right-angle adaptor properly installed with their shaft accessory.
For installation of the right angle adaptor, tablet holder or immersion probe please read
the guidelines for safe installation and use provided with the accessory. They are
included in the Appendix of the user manual as well.
To Next Page
Loading...
Need help?
General