To Next PageTo Next Page
Need help?Do you have a question about the Banner EZ-SCREEN LP and is the answer not in the manual?
General| Type | Light Screen |
|---|---|
| Resolution | 14mm, 20mm, 40mm |
| Operating Voltage | 24V DC |
| Response Time | ≤ 20ms |
| Housing Material | Aluminum |
| Protection Rating | IP65 |
| Number of Beams | 8 to 120 |
Emphasizes reading all safety and installation instructions before system setup.
General introduction to the EZ-SCREEN LP light screen.
Details product use cases and restrictions.
Explains system reliability features like redundancy and self-checking.
Lists key product functionalities like blanking and EDM.
Lists 14mm non-cascadeable emitter and receiver models.
Lists 25mm non-cascadeable emitter and receiver models.
Details available cables and connectors for system interface.
Lists optional add-on items for system enhancement.
Lists available spare parts for the system.
Lists related documentation and manuals.
Provides detailed technical specifications for the system.
Discusses physical mounting factors like safety distance and guarding.
Step-by-step guide for physically mounting sensors.
Guide for initial wiring and connections.
Procedure for initial system verification before machine connection.
Details connecting the system to the guarded machine.
Steps required before the system can be put into operation.
Features for sensor interchangeability and emitter hookup.
Defines roles for system operation and maintenance.
How to set up system parameters via DIP switches.
Steps for performing system resets.
Explains system status lights and diagnostic displays.
Describes standard operating states and modes.
Schedule for performing system checks.
Guide for resolving lockout conditions and errors.
Using test mode for diagnostics and verification.
Addresses potential issues caused by electrical or optical noise.
Discusses cleaning procedures and warranty service.
Outlines different checkout types and their frequency.
Procedure for initial system setup checkout.
Daily checks for system status and operation.
Six-month checks for system installation and changes.
Introduction to cascading light screen systems.
Lists 14mm cascadeable emitter and receiver models.
Lists 25mm cascadeable emitter and receiver models.
Guide for selecting appropriate cable lengths for cascades.
Calculating response times for cascaded systems.
Configuring scan codes, EDM, and other settings for cascades.
Steps for setting up cascaded systems.
Integrating emergency stop buttons into cascade systems.
Using safety interlock switches with cascade inputs.
Remote programming of fixed blanking feature.
How to choose between trip and latch output modes.
Details ways to connect the emitter.
Details EDM functionality and configurations.
Using the remote test function for setup.
Setting scan codes to prevent crosstalk.
Laser tool for sensor alignment.
Protective shields for sensor lenses.
Overall technical specifications including safety and environmental ratings.
Effect of reduced resolution on safety distance calculation.
Steps for physically mounting the emitter and receiver.
Specifics on installing end-cap mounting brackets.
Steps for initial power-up and optical sensor alignment.
Connecting the OSSD safety outputs to machine control.
Connecting Final Switching Devices (FSDs) for safety.
Connecting control elements and EDM inputs.
EDM configuration for one-channel monitoring.
EDM configuration for two-channel monitoring.
EDM configuration for no monitoring.
Guide for resolving lockout conditions and errors.
Outlines different checkout types and their frequency.
Procedure for initial system setup checkout.
Daily checks for system status and operation.
Six-month checks for system installation and changes.
Introduction to cascading light screen systems.
Components for cascaded systems.
Display indications for cascaded receivers.
Calculating individual response time and safety distance.
Calculating overall cascade response time and safety distance.
Configuring fixed blanking for cascaded sensors.
Requirements for positive-opening E-stop switches.
Monitoring multiple safety switches in series.
Procedures for programming fixed blanking remotely.
