Baofeng BF-H6 - Page 12

67.0HZ,…,
254.1HZ
D023N,…,
D754I
Scan
CTCSS
Scan
DCS
In frequency mode, the difference
between the transmitted and received
frequencies.
When save a channel, indicates the
channel number to be saved.
If a number is preceded by “CH-”, the
channel already has channel parame-
ters.
Deletes channel parameters for the
specified channel,
If no “CH-”indicates that the channel has
no parameters, the operation is invalid.
Automatic stop after receiving the
CTCSS signal
Automatic stop after receiving the DCS
signal
After releases the PTT, the radio will not
send the code. Usually, when passing
through the repeater, the radio will make
noise to confirm whether the signal of the
radio is transferred
When the PTT is released, the radio
sends the code, and the receiver makes
an instantaneous noise
PORTABLE TWO-WAY RADIO PORTABLE TWO-WAY RADIO
17 18
OFF
ON
OFF
ON
VFO
ALL
Preset Logo
Preset Msg
Voltage
Chinese
English
No
Level 1
menu
Level 2
menu
Description of settings
24
25
27
26
28
30
29
Alarm
Mode
Memory
000,…,127
Delete
Offset
TAIL
00.000,…,9
9.998
000,…,127
On site
Send sound
Send code
When transmitting across the repeater
and retransmitting, after the transmitter
releases the PTT key, the radio enters
receiving status. Due to the delay of
repeater, the instant signal transmitted
by the repeater can be received. The
value of the menu item shall be adjusted
to ensure that no noise of this radio is
generated when transmitting across the
repeater, so as to confirm whether the
relay is operating. The menu item shall
be set OFF.
When the signal is transmitted across
the repeater and retransmitted by it, in
order to confirm whether the repeater
has retransmitted the signal for this
radio, the delay time of the repeater
stopping transmitting shall be utilized to
confirm that the signal has been
retransmitted. The menu item is used to
adjust the time of the noise. If the noise
isn't needed, please set it as OFF.
Turn off the end of call prompt tone
Turn on the end of call prompt tone
Initialize of Menu
Initialize of Menu and channel
No
Level 1
menu
Level 2
menu
Description of settings
32
31
35
34
36
37
33
RP
_STE
RP
_STE
R-TONE
Reset
Power
On Msg
Lan-
guage
PROGER
OFF
1s,2s,3s…
10s
OFF
1s,2s,3s…
10s
1000hz,1450hz,1750hz,2100hz