up to 16 channels, either digital or analog. You can set the scan
list as follows by using this menu path: Scan -> Scan list.
Set priority channel
You can set the currently selected channel as a priority channel
or a non-priority channel. If you want to focus on activities on a
channel, set it as a priority channel. The priority channel is
sampled more often than that of non-priority channel. You can
set up to two priority channels in each scan list.
Sub-audio Scan
This product supports sub-audio scanning function. Operation
path: In analog mode, press the [MENU] button -> Set
->Radio Set > CTCSS/DCS CTCSS/DCS
->press the [*] button to enable sub-audio CTCSS finder
High/Low Power Adjustment
This feature enables fast switching of high and low power. When
the communication distance meets your needs, you can select
low power to save power. Please select high power flow power
does not allow you to communicate with other two-way radios
farther away.
Press the [#]button to switch the transmission power of the
current channel between high and low.
Note: The power level of each channel needs to be set
separately.
Talkaround
In case of a repeater failure or beyond the coverage of the
repeater, but two stations are within communication range of
each other, you can press [Talkaround] shortcut to switch or go to
press [MENU] button -> Set ->Radio Set -> Talkaround -> On
to enable direct communication between the two stations,
bypassing the repeater. Follow this sequence a second time to
disable Talkaround and enable communication through the
repeater again.
Monitor
Turn on the "Monitor" function to adjust the signal reception
match condition.
O Press and hold the [Monitor] shortcut to turn on this feature,
and the LCD shows icon( ; release the button to exit.
Squelch Level Adjustment
You can adjust the signal strength required to receive the signal
by adjusting the noise level. In general, the higher the squelch
level, the higher the required signal strength is. If it is set to
"Normally on", the speaker will directly turn on to play the
background sound, regardless of whether the decoding
conditions are met.
Push-to-call
You can ask the dealer to set [Push-to-call] shortcut, and press
the shortcut to initiate the corresponding operation. Specific
operation categories are as follows:
To Next Page
Loading...
