Business on digital channels.
» For group call contacts, you can initiate a group call or send
text message.
» For single call contacts, you can initiate single call, send text
message, and initiate extended function. Extended functions
include: call prompt, radio detection, remote monitor, activation,
and remote inhibit.
Call prompt
In digital mode, you can send call prompt to a contact, and the
other party can call back directly
Initiate call prompt:
Select single call contact (enter "Menu -> Contacts ->Press [A]
V ] to select single call contact ->CaIl prompt"), or press the *
button in the main interface to enter single call number, select
"Call prompt", and press the[MENU] button to start;"Call prompts
successful" displays if it is successful, and "Call prompt failed"
displays if fails.
Receive call prompt:
After receiving the call prompt command, a tone rings (tone
function is enabled for the caller's contact in the contact list) and
stays in the display interface. Press [EXIT] to exit.
View Radio Info
View the information about this product, including: own number
and radio model, serial number, CPS version, hardware version,
firmware version, DSP version, and programming time.
Menu path: Set ->Radio Info -> Radio ID
Device info menu path: Set ->Radio Info -> Device Info.
CTCSS 1 DCS
In analog channel, the speaker turns on only when the carrier
wave and sub audio match in order to avoid receiving irrelevant
call on the same frequency. Provide 51 sets of standard
CTCSS (analog sub audio) and also support non-standard sub
audio. Provides 108 sets of standard DCS (digital sub audio),
and also support non-standard DCS.
Sub-audio can be set via writing frequency software on the
reception or transmission CTCSS/DCS of analog channel or via
the "Set ->Radio Set -> CTCSS / DCS" path in the menu. If you
require DCS codes, press the [A/B] button to select digital sub
audio, press [ A v ] to select digital sub audio code, press
the # button to switch between positive phase (N) and negative
phase (l).
Press the [A/B]button to select regular CTCSS codes and
press [ A V ] to select analog sub audio frequency.
In CTCSS selection mode, press the * button to scan analog
sub audio. DCS codes can not be scanned or found using this
feature.
Configuring Two-way Radio
You can modify the frequency of current channel, channel
name, color code, relay station time slot and other radio
configuration information.
Configuration path: Enter "Settings ->Radio Configuration"
menu, and select the appropriate configuration items.
Frequency: Set the reception frequency and transmission
frequency. Please use the frequency in the range of this product.
To Next Page
Loading...
