c. [3][1] [1] [0] Deletes Prior Data in channel (Ex. 10)
d. [1][2] 123.0 Select desired TX encode tone (Ex 123 CTCSS)
-->>Use to select Upper display
e. Enter RX frequency (Ex. 43266250)
f. [3][0] [1][0] Enter the desired channel (Ex 10)
-->> Channel has been added
g. Press [VFO/MR] key to return to the MR mode and the channel number will reappear.
6.4 Repeaters Programming
The following instructions assume that you know what transmit and receive frequencies your repeater employs, and that
you're authorized to use it.
a. Press [VFO/MR] key to set the radio to VFO mode, and the VFO icon is displayed on the right.
b. Use the numeric keypad to enter the repeater's output (your receiving) frequency.
c. Press the key to enter the menu.
d. Enter [2][9] on the numeric keypad to get to frequency offset.
e. Press key to select.
f. Use the numerical keypad to enter the specified frequency offset. See the section called “29 OFFSET - Frequency shift
amount” for details.
g. Press key to confirm and save.
h. Enter [2][8] on the numeric keypad to get to offset direction.
i. Use the / keys to select + (positive) or - (negative) offset.
j. Press key to confirm and save.
k. Optional:
a). Save to memory, see the section called “Manual programming” for details.
b). Set up CTCSS; see the section called “CTCSS” for details.
l. Press key to exit the menu. If everything went well, you should be able to make a test call through the repeater.
NOTE:
If you're experiencing problems making a connection to the repeater, check your settings and/or go through the procedure
To Next Page
Loading...
