Baofeng UV82 - 1750 Hz Tone for Repeaters; Repeater Tone Usage; Basic Operation; Radio On-Off and Volume Control

1750 Hz TONE FOR ACCESS TO REPEATERS
The user needs to establish long distance communications through an amateur radio repeater which
is activated after receiving a 1750 Hz tone. Press and hold on the [PTT] ,then press the IF]
button to transmit a 1750Hz tone.
BASIC OPERATION
RADIO ON-OFF/VOLUME CONTROL
-Make sure the antenna and battery are installed correctly and the
battery charged.
-Rotate the knob clockwise to tum the radio on, and rotate the knob
fully counter-clockwise until a ‘click’ is heard to turn the radio off.
Tum the knob clockwise to increase the volume, or counter-clockwise
to decrease the volume.
SELECTING A FREQUENCY OR CHANNEL
-Press the key [4] or ['V] to select the desired frequency/channel you want. The display shows
the frequency / channel selected.
-Press and hold down the key [J or IW] for frequency up or down fast
Note: You can not select a channel if not previously stored.
ADVANCED OPERATION
You can program your transceiver operating in the setup menu to suit your needs or preferences.
SET MENU DESCRIPTION
Menu Function/Description Available settings
0 _| SQL (Squeich level) 0-9
1_|_STEP(Frequency step) 2.5/5/6,25/10/12.5/20/25kH2
2 TXP(Transmit power) HIGH/LOW-
3___| SAVE( Battery save,1:1/1:2/1:3/1:4) OFF/1/2/3/4
4 VOX(Voice operated transmission) OFF/0-10
5 WIN( Wideband/narrowband) WIDE/NARR
6 _| ABR(Display illumination) OFF/1/2/3/4/58
7__| TDR(Dual watch/dual reception) OFFION
8 _ | BEEP(Keypad beep) OFFION
9 | TOT(Transmission timer) 15/30/45/60.../585/600seconds
10 _| R-DCS(Reception digital coded squelch) OFF/DO23N...07541
Ti_ | R-CTS(Reception Continuous Tone Coded Squelch) 67.0Hz,,.254.1Hz
12_ | T-DCS(Transmission digital coded squelch) OFF/DO23N,..07541
13__| T-CTS(Transmission Continuous Tone Coded Squelch) 67.0Hz,,.254.1Hz
14_| VOICE(Voice prompt) OFF/ON
15. | ANl(Automatic number identification of the radio,only
can be set by PC software.
16 _| DTMFST(The DTMF tone of transmitting code.) OFF/DT-ST/ANI-STIDT+ANI
17_| S-CODE(Signal code, only could be set by PC software.) Tis15 groups
18_| SC-REV(Scan resume method) TOICOISE
19__| PTT-ID(press or release the PTT button to transmit the signal code) | OFF/BOT/EOT/BOTH
20__| PTT-LT(delay the signal code sending) 0.....30ms