(2) Lamp switch: Pull shiftⅠ, front and rear clearance lamps light. Pull shiftⅡ, the
head lamps light while the clearance lamps light too.
(3) Steering signal: Pull the steering lamp switch backward, the front and rear
combination turning signals on the left side of the truck light; pull the turning lamp switch
forward, the front and rear combination turning signals on the right side light.
(4) Brake signal: When braking, press down the brake pedal and turn on rear
combination brake lamps (red) light.
(5) Reverse signal: When reversing the truck, pull the direction switch backward, then
the travel motor reverses, rear combination reversing lamps (white) light and the back-up
buzzers sound.
2.6.3 Electric forklift truck with AC motor
(1) Start: Before starting, put the hand brake switch on the brake position, the shift
direction switch and seat switch on neutral, turn on the urgent power-down switch. If not,
the safe circuit plays its part, and then the forklift truck can’t start.
Turn the start switch clockwise to shift Ⅰto turn on the power, meter indicator and
electric control circuit, release the hand brake switch.
Push the shift direction switch forward, press down the accelerator pedal, then the
truck goes forward. If pull the direction switch backward, the reverse lamps light and the
back-up buzzers sound. If having operational errors or others, the meter will show
different error codes, some common features as follows:
If pressing down the accelerator pedal first, then turning on the direction switch, the
meter will show code 64 expressing start error.
When turning on the key switch, meter shows error code 50, it expresses that the lift
is in the state of start-up.
If the voltage of the battery is too low, the error code 12 will indicate.
When meter shows code 40, the lift sensor is wrong.
The common error code as 90, it shows failure steering sensor or the damaged or
loosen sensor.
(2) Lamp switch: Pull shiftⅠ, front and rear clearance lamps light; pull shiftⅡ, the head
lamps light while the clearance lamps light too.
(3) Steering signal: Pull the steering lamp switch backward, the front and rear
To Next Page
Loading...
