Baoli F Series - Page 52

46
(3) Noisy gear box
Parts
Problem
Possible cause and remedy
Torque
converter
1. Elasticity plate is broken
Check noise and replace elasticity plate.
2. Damaged or worn bearing
Check or replace
3. Gear is broken
Check or replace
4. Spline is worn
Check or replace
5. Noisy main pump
Check or replace
6. Loosen bolt
Check, tighten or replace.
Gear box
1. Bearing is worn
Check or replace
2. Gear is broken
Check or replace
3. Spline is worn
Check or replace
4. Loosen bolt
Check, tighten or replace.
(4) Too low transmission efficiency
Parts
Problem
Possible cause and remedy
Torque
converter
1. Elasticity plate is broken
Check noise and replace
2. Lower oil amount
Check oil level and add oil
3. Ineffective driving system of oil
pump
Check and replace
4. Shaft is broken
Check and replace
5. Too low oil pressure
Check oil pump for suction pipe
Gear box
1. Lower oil amount
Check oil level and add oil
2. Seal ring is worn
Check and replace
3. Slipped clutch
Check oil pressure of the clutch
4. Shaft is broken
Check and replace
5. Clutch cap is broken
Check and replace
6. Retainer ring of clutch cap is
broken
Check and replace
7. Foreign matter mixed in oil tank
Check, clean or replace.
8. Spline of shaft is worn
Check and replace
(5) Oil leakage
Parts
Problem
Possible cause and remedy
Torque
converter
or gear
box
1. Worn seal ring
Check and replace seal ring
2. Incorrect connection of case
Check, tighten or replace.
3. Loose connector and oil pipe
Check, tighten or replace.
4. Loose drain plug
Check, tighten or replace.
5. Oil spray from vent hole
Check connector, air hole or replace
pipe.
6. Much oil
Check oil level and drain surplus oil