3
CONGRATULATIONS
Congratulations on your purchase of one of the easiest to
configure controllers on the market. After a four step
configuration procedure, your process will be up and running.
GUIDE TO SIMPLE SET-UP
Only four steps are required to set-up your controller:
1. Wire the instrument (page 7).
2. Configure the instrument (page 13).
3. Check the operating mode parameters (page 24).
4. Check the autotune (Smart AT) process (page 20).
Unpack the
Instrument
Wiring
Configuration
Operating
Parameters
Autotuning
SV
To Next Page
Loading...