4780 0318
HYDRAULIC MOLDBOARD (OPTION) The hydraulic moldboard is moved up and down by two double
acting cylinders. This option requires a set of remote valves on the tractor. The two hoses connect to one
rear remote valve.
ELECTRONIC COMPONENTS (OPTIONS)
Electrical diagrams for all component options are located at the end of this manual.
POWER CABLE The towing tractor supplies the Surf Rake
®
and all its electronic
components with power through a seven conductor cable. The cable runs from the
tractor to the junction box on the Surf Rake
®
. Wiring diagrams are located at the
back of this manual – refer to the table of contents. See Picture.
LIGHTING (OPTION) The lighting circuit is comprised of left and right molded light assemblies, an electrical
harness that connects to the towing vehicle’s lighting system. The Electrical Plug is a 7-pin configuration.
Wiring diagrams are at Section 6-14.
To Next Page