1. Safety
Power input AC clip
Image 1-1
Type A
Image 1-2
Type A
Image 1-3
Type C
Image 1-4
Type G
Image 1-5
Type I
1.6 Compliance FCC
Federal Communication Commission Interference Statement
You are c autioned that changes or m odifi c ations not expressly approved by the part responsible for com pliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the lim its for a Class B digital device, pursuant to Part 1 5 of the FCC rules.
These lim its are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can ra diate radio freque ncy energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio com munications. However, there is no guarantee that interference will not oc cur in a particular
installation.
If this equipment does cause harmful interference to radio or television rece ption, which can be determined by turning the equipment
off and on , the u ser is encour aged to try to c orrect the interference by one or m ore of the following measures:
• Reorient or re locate the receiving a ntenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit d ifferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
You m ay also fin d helpful the following booklet, prepared by the FCC : "How to Identify and Resolve Radio-TV Interference Problems."
This booklet is available from the U.S. Governm ent P rinting O ffice, Washington D.C. 20402.
Changes and Modifications not expressly approved by the manufacturer or r egistrant of this equipm ent can void your authority to
operate this eq uipment under Federal Communications Commissions rules.
In order to maintain compliance with FCC reg ulations shielded c ables must be us ed with this equipment. Operation with non-ap-
proved equipment or unshielded cables is likely to result in interference to radio & television recep tion.
FCC R F Radiation Exposure Statement: T his dev ice is capable of operating in 802.11a mode. For 802.11a dev ices operating in the
frequency range of 5.15 - 5.25 G Hz, they are restricted for indoor operations to reduce any potential harmful interference for M obile
Satellite Services (M SS) in the US. WIFI Access P oints that are capable of allow ing your device to operate in 802.11a mode (5 .15
- 5.25 GHz band) are optimized for indoor use only. If your WIFI network is capab le of ope rating in this m ode, please restrict your
WIFI u se indoors to not v iolate federal regulations to protect Mobile Satellite S ervice s.
Base Unit FC C ID: 2AAED-R9861510
Button FCC ID (model R9861006D01): XF6-RS9110N1103
Button FCC ID (model R9861500D01): 2AAED-R9861500D01
ClickShare Button R9861500D01 has been tested and meets the FCC RF exposure guidelines.The maximum SAR value reported
is 0.915W/kg.
1.7 EN55022-CISPR22 Class B ITE (Information Technology Equipment)
Warning
This is a class B product. In a dom estic env ironmen t this pr oduct may cause radio interference in which case the user may be
required to take ade quate m easures.
If this equipment does cause interference to radio or television reception, the user may try to correct the interference by one or mo re
of the following measures :
• Re-orientation of the receiving antenna for the rad io or television.
• Relocate the equipm ent with respect to the receiver.
• Plug the equipment into a different outlet so t hat the equipment and receiver are on different branch c ircuits.
• Fasten cables connectors to t he equipment by mounting screws.
4
R5900031 CLICKSHARE CS-100 01/06/2016
To Next Page
Loading...
Need help?
General
Weight and Dimensions
