Barco Coronis 5MP - First Time Starting up

To Next Page

To Previous Page

26 Coronis 5MP

First time starting up

You are now ready to start up your BARCO CORONIS Display System for the

first time.

1 Switch on your B

ARCO CORONIS Display as described in “Stand-by

switching” on page 29.

2 Turn on the computer connected to your display.

If you have properly installed your display and display controller, the

Windows start-up messages will appear once the boot procedure is

finished.

Your BARCO CORONIS Display will be running in a basic video

mode at a default refresh rate when first time starting up.

If you are using a Barco display controller, please consult the

user guide delivered with it to install the drivers, software and

documentation. When this is done, your display will

automatically detect the connected video input signal(s) and

apply the correct video mode and refresh rate.

Other manuals for Barco Coronis 5MP