50 Coronis 5MP
TO MANUALLY SELECT A GRAYSCALE CONVERSION MODE:
1 Bring up the OSD main menu.
2 Navigate to the Configuration > Image Source menu.
3 Enter the Grayscale Conversion submenu.
4 Select one of the available color conversion modes and confirm.
EDID timings
ABOUT EDID TIMINGS
Following EDID timings are available for your BARCO CORONIS Display:
TO MANUALLY SET EDID TIMINGS:
1 Bring up the OSD main menu.
2 Navigate to the Configuration > Image Source menu.
3 Enter the Timings submenu.
4 Select Refresh Rate, Preferred Orientation or Color Depth.
5 Select one of the available settings and confirm.
Refresh Rate Allows to manually select the refresh rate
of the image source video input signal
depending on the maximum refresh rate of
the display controller connected to your
display.
Preferred Orientation Allows to change the orientation of the
image source video input signal to
landscape, portrait or to let the display
automatically assign the correct
orientation.
Color Depth Allows to change the color depth to 8 or to
10 bit.
To Next Page
Loading...
