1. Safety
• Never place the projector in direct s un light. Sun light on the lens can severely d amage the Digital Mirror Devices
TM
in wh ich
case there is a loss of warranty.
• Save t he original shipping carton and pack ing material. T hey will come in handy if y ou ever have to ship your equipment. For
maximum protection, repack your s et as it w as o riginally packed at the factory.
• Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a dam p cloth for
cleaning. Never use strong solvents, such as thinner or benzine, or abra sive cleaners, since these will damage the cabinet.
Stubborn s tains may be removed with a cloth lightly dampened w ith mild detergent solution.
• To ensure the highest o ptical performance and resolution, the projection lenses are specially treated with an anti-reflective
coating, therefore, avoid touching the lens. To remove dust on the lens, use a soft dry cloth. Do not use a
damp cloth, detergent
solution, or thinner.
• Rated max imum ambient temperature, t
a
=35°C(95°F).
• The lamp hou se shall be replaced if it has become damaged o r thermally deformed.
On servicing
• Do not attempt to service this product yourself, as o pening or removing covers may expose you to dan gerous voltage potentials
and risk of electric shock.
• Refer all s ervicing to qualified service personnel.
• Attempts to alter the factory-set internal controls or to c hange o ther control settings not specially discussed in this m anual c an
lead to permanent dam age to the projector and cancellation of the warranty.
• Unplug this pr oduct from the wall outlet and refer servicing to qualified service technicians under the following conditions:
- When the power cord or plug is damaged or frayed.
- If liquid has bee n spilled into the equipment.
- If the produ ct has been exposed to rain or water.
- If the product does not operate norm ally when the operating instructions are f ollowed. Adjust only those controls that are
covered by the operating instructions since im proper adjustment of the other controls may result in damage and will often
require extensive work by a qualified technician to restore the pr oduct to normal operation.
- If the product has been dropped or the cabinet has been damaged.
- If the product exhibits a distinct change in performance, indicating a need for service.
• Replacement parts: When replacement parts ar e required, be sure the service technician has used original Barco replacement
parts or authorized replacement parts which have the same characteristics as the Barco original part. Unauthorized substitu-
tions m ay result in degraded performance and reliability, fire, electric shock or other hazards. Unauthorized substitutions may
void w arra nty.
• Safety chec k: Upon completion of any service or repairs to this projector, ask the service technician to perform safety checks
to determine that the product is in proper operating condition.
• Possible explosion hazard: Always keep in mind the caution below:
CAUTION: Xenon co mp act arc lamps are highly pressu rized. W h en ignited, the normal operating temp erature
of the bulb increases the pressure to a level at w hich the bulb ma y explode if not handled in strict accordance
to the manufacturer’s instructions. The bulb is stable at room temperature, but may s till explode if dropped or
otherwise m ishandled . Wh enever the lamp h ouse, containing a xenon lamp, has to be disman tled or whenever
the protective container or cloth has to be remove d from the xenon lamp, authorized pro tective clothing MU ST
be worn!
To prevent battery explosion
• Danger of explosion if battery is incorrectly installed.
• Replace only with the same or equivalent type recommended by the m anufacturer.
• For disposal of used batteries, always consult federal, state, local and provincial hazardous waste disposal rules and regulations
to ensure proper disposal.
4
R59770352 DP2K-20C 01/10/2009