Need help?Do you have a question about the Barco DP2K-6E and is the answer not in the manual?
General| Contrast ratio (typical) | 1600:1 |
|---|---|
| Projector native resolution | 2K (2048x1080) |
| Ethernet LAN | Yes |
| Ethernet LAN (RJ-45) ports | 3 |
| Noise level | 48 dB |
| AC input voltage | 200 - 240 V |
Outlines essential safety guidelines and warnings for projector operation.
Provides critical safety instructions to prevent electrical shock and personal injury.
Explains safe distances from the light beam to prevent eye injury.
Details safety measures when handling cleaning agents and hazardous chemicals.
Specifies environmental and technical conditions for projector installation.
Offers a comprehensive checklist of steps for setting up the projector.
Details how to physically mount and orient the projector for optimal placement.
Explains the procedure for connecting the projector to the main AC power supply.
Provides detailed steps for installing a lens into the projector's lens holder.
Explains how to adjust the lens for image geometry and focus.
Describes the ICP board, its LEDs, and diagnostic functions.
Introduces the ICMP(-X) as a core component for DCI cinema content.
Explains the HDD configuration (RAID 5) and storage capacity of the ICMP(-X).
Provides instructions for physically installing a hard disk drive into the ICMP(-X).
Explains the purpose and importance of the ICMP(-X) device certificate for content playback.
Details the essential steps for safely powering on the Athena projector.
Explains the correct procedure for powering down the projector and its components.
Provides detailed steps and required tools for performing Scheimpflug adjustment.
Explains how to align the blue pattern with the red pattern for image convergence.
Explains how to align the green pattern with the red pattern for image convergence.
Details the safe procedure for removing the lamp module from the projector.
Guides users on how to correctly install a new lamp house module.
To Next Page