Need help?Do you have a question about the Barco DP2K-36BLP and is the answer not in the manual?
General| Projector Type | Digital Cinema Projector |
|---|---|
| Brightness | 36, 000 lumens |
| Aspect Ratio | 1.89:1 (native) |
| Cooling System | Liquid cooling |
| Resolution | 2048 x 1080 |
| Technology | DLP |
| Contrast Ratio | 2000:1 |
| Lamp Life | 30, 000 hours |
| Inputs | HDMI, DVI, Ethernet |
| Operating Temperature | 5°C to 35°C |
| Warranty | 3 years |
| Color Processing | 14-bit |
| Lens Options | Multiple Barco CinePro lenses available |
Details crucial instructions to prevent electrical shock and other hazards.
Explains precautions for high brightness lasers and the concept of Hazard Distance.
Outlines environmental conditions and altitude requirements for safe projector operation.
Details the step-by-step process for installing the projector from start to finish.
Describes the assembly and installation steps for the top cooler unit.
Outlines the steps for installing the stand-alone cooler unit.
Covers initial startup procedures and system adjustments after installation.
Provides guidelines for physically positioning the projector in the installation area.
Explains how to configure the power input for the DPxK-36BLP model.
Guides on connecting the DPxK-17/23BLP projector to the power supply.
Provides instructions for connecting the DPxK-36BLP projector to the power supply.
Details how to connect a UPS unit to the projector's electronics for power backup.
Guides on mounting the cooling frame onto the projector unit.
Guides on inserting the cooler units into the cooler housing.
Provides instructions for connecting the cabling and tubing for the stand-alone cooler.
Guides users on how to select the appropriate lens using the Barco website calculator.
Provides a step-by-step guide on how to install a lens into the projector's lens holder.
Explains the procedure for safely removing a lens from the projector.
Details how to use the motorized lens shift, zoom, and focus functionalities.
Describes the Integrated Cinema Processor (ICP) board, its LEDs, and functions.
Details the ICMP's Hard Disk Drives (HDDs), RAID configuration, and modes.
Details the necessary tools and steps for installing the touch panel interface.
Provides a step-by-step procedure for switching on the projector.
Details the correct procedure for switching off the projector.
Step-by-step guide on removing and cleaning the front dust filter.
Instructions for removing and cleaning the bottom dust filters.
Guides on the proper procedure for cleaning the projector lens.
Guides on opening the projector's sealed compartment for adjustments.
Details how to properly close the projector's sealed compartment.
Provides instructions for adjusting the red convergence relative to the blue pattern.
Details how to adjust the green convergence relative to the blue pattern.
Outlines the overall process for color calibration, including aspect ratio and white point.
Explains how to perform white point calibration for color stability.
Details the process of color gamut calibration to match target color spaces.
To Next Page
