Need help?Do you have a question about the Barco DP2K-19B and is the answer not in the manual?
General guidelines and warnings for safe operation and installation.
Critical instructions to prevent electrical shock and personal injury.
Guidelines for handling hazardous chemicals used in the projector.
Information on optical radiation safety and hazard zones.
Environmental and power requirements for safe projector installation.
Step-by-step guide for safely unpacking the projector.
Guidelines for placing the projector at the port window.
Instructions for installing the mandatory exhaust system.
Steps for connecting the projector to the mains power.
Instructions for connecting an uninterruptible power supply.
List of compatible xenon lamps and adapters.
Procedure for safely removing the lamp house assembly.
Step-by-step guide for lamp removal.
Detailed instructions for lamp installation.
Procedure for installing the lamp house back into the projector.
How to update lamp information after replacement.
Guidance on choosing the correct lens for the application.
Step-by-step instructions for installing a lens.
Procedure for safely removing a lens from the holder.
How to adjust lens parameters for image positioning.
Adjusting focus range for optimal image sharpness.
Overview of the ICMP(-X) module.
Details on the ICMP(-X) hard drive configuration.
Scenarios for replacing or reusing HDDs.
Procedure for installing a new HDD.
Procedure for removing an HDD.
Information on the device certificate and its purpose.
Configuring the ICMP(-X) using the software.
Instructions for mounting and connecting the touch panel.
Steps for adjusting red channel convergence against blue.
Steps for adjusting green channel convergence against blue.
To Next Page
General