2. General
The projector is d elivered with a plastic co ver inside the Lens Holder. T his to prevent intrusion o f dust and
foreign particles.
The lens is delivered in a separate box. For len s installation, see section “Lens & lens holder”.
2.4 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mec hanical and electrical defects. As soon as the projector is
unpacked, inspect for any damage that may have occurred in transit. Save all packing material until the inspection is completed. If
damage is found, file claim with carrier imm ediately. The Barco Sa les and Service office should be notified as soon as possible.
The packaging of the DP xK BLP series projector is provided with a sho ck-watch label. If this shock-watch
label was triggered (red colored at arrival) du ring transpo rt, indicates that the p ackage was possibly roughly
handled by the transport company. In this case, the instructions mentioned on the label, should be followed,
which are: adding a note on the “bill of lading” and informing the transport company and the Barco sales and
service office as s oon as possible.
Projector Box content
After unpacking the projector it is recom men ded to check if all following items where included:
• One short power link cable (mono phase) (in case no UPS is used) - Installed on projector.
• A short information notice to inform the user that ins tallation manual (this manual) is available online on the Barco webs ite.
• Safety manual
The projector lens are not included in the p ackage of the projector.
Mechanical check
This check should confirm that there are no broken knobs or connectors, that the cabinet and panel surfaces ar e free of dents and
scratches, and that the operating panel is no t scratched or cracked. The Barco Sales and Service office should be notified as s oon
as possible if this is not the case.
Tamper labels
During installation please insp ect the tamper labels, if they are damaged please c ontact Barco tech support.
The tamper labels are required by DCI to provide easy visual indication if the equipment was tampered with. The projectors are
tested and labeled for shipping to ensure that the s ystem was not com promised before reaching the customers final d estination.
These tam per labels can be found behind the input c
over. See "Removal of the input cover", page 122.
22
R5906753 DPXK BLP SERIES 20/11/2017
To Next Page
Loading...
