1. Safety
WARNING: No direct exposure to the beam within the hazard distance shall be permitted, RG3 (Risk Group
3) IEC 62471-5:2015
CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazard ous radiation expo sure.
Restricted access location
This product may only be installed in a restricted access location. The definition of a “restricted access location" is a location for
equipment where both of following applies:
• Access can only be gained by SERVICE PE RSON N EL or by OPE RATORS who have been instructed about the r easons for
the restriction applied to the location and abou t the precautions that shall be taken.
• Access is through the use of the tool or lock and k ey, or other mea ns of security, and is controlled by the authority responsible
for the location.
Why a restricted access location: This is a RG 3 product. Based on international requirem ents, no per son in allowed to enter the
projected beam within the zone between the projection lens and the related Hazard Distance (HD). This shall be physically impossible
by creating sufficient s eparation height or by placing optional barriers. Within the restricted area op erator training is considered
sufficient. The applicable separation heights a re d iscussed in "High Brightness precautions: H azard Distance (HD)", page 11.
Users definition
Throughout this manual, the terms SERVICE P ERSO NNEL and TRA INED PROJECTIONIST refers to p ersons ha ving appropriate
technical training and ex perience necessary to be knowledgeable of potential hazards to which they are exposed (including, but not
limited to HIGH VOLTAGE ELE CTRIC and ELECTRONIC CIRCUITRY and HIGH BRIGHTNESS PROJECTORS) in performing a
task, and of measures to minimize the potential risk to thems elves or other persons. The term USER and O PER ATOR refers to
any person other than SERVICE PERSON NEL or TRAINED PROJECTIO NISTS, AUT HO RIZED to op erate professional projection
system s.
The TRA INED PROJE CTIONIST S may only perform the maintenance task described in the Use r & Installation manual. All other
maintenance tasks and service tasks must be performed by qualified SERVICE PERS O NNEL.
The DLP Cinema Systems are intended "FOR PRO FESS IONAL USE O NLY" by AUT HO RIZED PERSONNE L familiar w ith potential
hazards associated with high voltage, high intensity light beams generated by lasers. Only qualified SERVICE PERS ONNE L and
TRAINED PRO JE CTIONISTS, knowledgeable of such risks, ar
e allowed to perform se rvice functions inside the product enc losure.
Owner ’s record
The part n umber and serial number are printed on a label which is stuck on the respective part. Record these num bers in the spaces
provided below. Refer to them whenever you call upon your Barco dealer reg arding this product.
Product article n umber
Product serial num ber
Dealer
1.2 Important safety instructions
To prevent the risk of electrical shock
• This projector should be operated from an A C power source. E nsure that the mains voltage and c apacity matches the projector
electrical ratings. If you are unable to install the AC requirements, contact your electrician. Do not defeat the purpose of the
grounding.
• Installation according to the loc al electrical code and regulations by qualified technical personnel o nly.
• This product is equipped with a barrier strip for the connec tion of a power line. T he configuration depends on the projector:
- DPxK-17BLP/23B LP: three-terminal barrier strip for the connection of a mono phase power line with a separate earth ground
PE.
- DPxK-36BLP: fi ve-terminal barrier strip for the connection of a 3W +N+PE or 3 W+P E power system.
If you are unable to install the A C Requirements, con tact your elec trician. Do n ot defeat the purpose of the grounding.
6
R5906753 DPXK BLP SERIES 20/11/2017