R5906790 /04 Athena 23
Image 3-4
6. Remove the plastic cover from the Lens Holder opening.
After unpacking, allow the projector to acclimatize to a room temperature ranging from 10°C (50°F)
to 35°C (95°F) MAX. Neglecting this may result in a start up failure of the Light Processor Unit.
3.3 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As
soon as the projector is unpacked, inspect for any damage that may have occurred in transit. Save all packing
material until the inspection is completed. If damage is found, file claim with carrier immediately. The Barco
Sales and Service office should be notified as soon as possible.
The packaging of the Athena is provided with a shock-watch label. If this shock-watch label was
triggered (red colored at arrival) during transport may indicate rough handling by the transport
company. In this case, the instructions mentioned on the label, should be followed, which are:
adding a note on the “bill of lading” and informing the transport company and the Barco sales and
service office as soon as possible.
Box content
• Projector.
• User and installation manual (this document).
• Safety manual.
The projector lens is not included in the package of the projector.
Mechanical check
This check should confirm that there are no broken knobs or connectors, that the cabinet and panel surfaces
are free of dents and scratches, and that the operating panel is not scratched or cracked. The Barco Sales
and Service office should be notified as soon as possible if this is not the case.
Getting started
To Next Page
Loading...
Need help?
General
