Barco DP2K-6E User Manual

R5906790 /04 Athena122
3
3
3
4
Image 13-4
6. Check UHP power cable for dust and damage. See service manual for detailed procedure.
13.3 Installation of the Lamp House
WARNING: This procedure may only be performed by qualified technical service personnel.
Required tools
7mm nut driver or flat screw driver.
How to install the Lamp House in the projector?
1. Insert the Lamp House as follows:
1. Grip the Lamp House by the handle (4) and support it at the bottom with the other hand. Slide the Lamp
House in the lamp compartment.
2. Carefully insert the Lamp House into the projector. Make sure the positioning pins (reference 5, Image 13-
1) match the holes in the projector.
3
3
3
4
Image 13-5
Lamp House

Barco DP2K-6E Specifications

General

Contrast ratio (typical)	1600:1
Projector native resolution	2K (2048x1080)
Ethernet LAN	Yes
Ethernet LAN (RJ-45) ports	3
Noise level	48 dB
AC input voltage	200 - 240 V