Barco DP2K-6E User Manual

R5906790 /04 Athena 145
1
1
Image 16-10
2. Fasten the side cover plate into place with four screws at the top and two screws at the bottom (reference 1,
Image 16-10). Use a 3 mm Allen key.
CAUTION: Opening the Light Processor compartment by removing the top cover plate or side cover
plate will result in a tamper event. An authorization to clear the security warning on the projector,
after closing off the Light Processor compartment, will be needed!
16.9 Installation of the top cover plate of the Light
Processor compartment
Required tools
3 mm Allen key
How to install the top cover plate from the Light Processor compartment?
1. Install the top cover plate as follows:
1. Position yourself on the right side of the projector, and place the cover on an angle as shown.
2. Lower the top cover plate completely.
3. Slide the top cover plate towards the back of the projector until all slots of the top cover plate are properly
engaged (reference Image 16-11).
Removal and installation of the projector covers

Barco DP2K-6E Specifications

General

Contrast ratio (typical)	1600:1
Projector native resolution	2K (2048x1080)
Ethernet LAN	Yes
Ethernet LAN (RJ-45) ports	3
Noise level	48 dB
AC input voltage	200 - 240 V