R5906790 /04 Athena24
Tamper labels
During installation please inspect the tamper labels, if they are damaged please contact Barco tech support.
The tamper labels are required by DCI to provide easy visual indication if the equipment was tampered with.
The projectors are tested and labeled for shipping to ensure that the system was not compromised before
reaching the customers final destination.
These tamper labels can be found on the top cover plate from the Light Processor compartment, the side
cover plate from the Light Processor compartment, on the internal cover of the card cage and on the ICMP.
See chapter “Removal and installation of the projector covers”, page 137, for instructions on how to remove
the projector covers.
Image 3-5: Barco tamper label (required for DCI).
Getting started
To Next Page
Loading...
Need help?
General
