Barco R9002380 - Which Source to Which Input; Connecting a Composite Video Source

Connections
2-2 5976066 BARCOCINE 7 011299
Source No Projector input Press digit button
1 Comp. Video 1
2 S-Video* 2
3 RGBS or RGsB** 3
3 RGB3S or RG3sB*** 4
3 (R-Y)Y(B-Y)S or
(R-Y)Ys(B-Y)**** 5
3 (R-Y)Y(B-Y)3S or
(R-Y)Y3s(B-Y)***** 6
Connecting a Composite Video source.
Composite video signals from a VCR, OFF air signal decoder, etc..
Note :
If a line doubler or line multiplier is built in, the default position of this line doubler (multiplier) soft option is ON (active). The video input
signal will be displayed as a non interlaced image (= improved image stability).
To enable or to disable this function, enter the adjustment mode and change the position of the ON/OFF toggle switch (see chapter
'Random access' adjustment mode).
TV tuner, e.g. MARCO POLO
VCR
Audio amplifier
Composite
video
COM M PO RT
(800 peripherals)
REMOTE
RG(S)B
S
VIDEO
S-VIDEO
R- Y Y(S)
B-Y
RS232 OUTRS232 IN
COMM PORT
(800 peripherals)
REMOTE
RG(S)B
S
VIDE O
S-VIDEO
R-Y Y(S) B-Y
RS232 OUTRS232 IN
Which source to which input
* Input signal Y/C (luma/chroma)
** Input signal : R, G and B with composite sync on G or separate composite sync
*** Input signal : R, G and B with Tri level sync on G or separate Tri level sync.
**** Input signal : R-Y, Y and B-Y with composite sync on Y or separate composite sync
***** Input signal : R-Y, Y and B-Y with Tri level sync on Y or separate Tri level sync.