Barco R9002380 - Connecting a S-Video or Video Source to Port 2

To Next Page

To Previous Page

Connections

2-3

5976066 BARCOCINE 7 011299

Input selection

a. with the RCU : press digit button 2 or

b. with the local keypad.

(for access to the local keypad, see 'Local keypad' in chapter 'getting Started'.)

1 press ADJUST key, the General access menu is displayed on the screen (menu 1).

2 use the cursor keys to highlight

3 press ENTER to display the source.

GENERAL ACCESS

Select with ,

then <ENTER>.

<EXIT> to return

SHARPNESS

TINT

COLOR

BRIGHTNESS

CONTRAST

5 6

3 4

1 2

Enter ADJUST

COMM PORT

(800 peripherals)

REMOTE

SVIDEO

S-VIDEO

VCR S-VHS Audio amplifier

Luma/Chroma

RG(S) B

R-Y Y(S) B-Y

RS232 OUTRS232 IN

Video input selection :

a. with the RCU : press digit button 1 or

b. with the local keypad.

(for access to the local keypad, see 'Local keypad' in chapter 'getting Started'.)

1 press ADJUST key, the General access menu is displayed on the screen (menu 1).

2. use the cursor keys to highlight

3. press ENTER to select the highlighted source.

menu 1

Connecting a S-Video or Video source to port 2.

Separate Y-luma/C-chroma signals for higher quality playback of Super VHS signals.

Note :

If a line doubler or line multiplier is built in, the default position of this line doubler (multiplier) soft option is ON (active). The video input

signal will be displayed as a non interlaced image (= improved image stability).

To enable or to disable this function, enter the adjustment mode and change the position of the ON/OFF toggle switch (see chapter

'Random access' adjustment mode).