Basic Remote Command
result
RCU action Remark
return to previous menu without
selecting
press "menu"
MENU
move through menu press "arrow keys"
select button press "enter"
The enter button selects a item when in the
menu.
When not in the menu the enter button will
activate the lens adjust function.
select and return to previous menu press "enter"
adjust aspect ratio press "aspect ratio"
ASPECT
RATIO
halt projection temporarily press "pause"
PAUSE
The pause button will have a picture mute with
shutter close
operate the OSD menu normally or not press "text"
TEXT
When text is set to on, user can operate the
OSD menu normally. If set to Off, only can
use ON, OFF, 1~5, SWAP, PIP and PAUSE these
function
resync the image press "auto image"
This function also apply to PIP input
increase or descrease image contrast press "contrast"
1
increase or descrease image brightness press "brightness"
adjust image sharpness press "sharpness"
adjust image phase press "phase"
When the image flicker, doubles, distorts or
appeare wavy, use this function to adjust
adjust image color saturation press "color"
press "tint" This function not availavle for this model
display or hide pip press "PIP"
PIP
swap the input source of PIP press "swap"
SWAP
change receiving address of the remote
control
press "address"
ADDRESS
*only 2 address are possible*
Press and hold the ENTER until the remote
control panel flash once(approximately 5
seconds) to change the receiving address of
the remote control. if you use one remote
control to perate 2 different projectors. You can
assign different address for the 2 projectors so
that when you operate projector A, projector B
will not be affected.
To Next Page
Loading...
