Barco SLM R12+ - Baud Rate Setting; Setting up the Interface Standard

9. Service Mode
9.7.2 Baud rate Setting
Set up
To change the baud rate, handle as follow:
1. Push the cursor key ↑ or ↓ to highlight Baudra te. (menu 9-19)
The actual baud rate will be displayed.
2. Press ENTER to toggle between the available baudrates.
Default : 9600
SERIAL COMMUNICATION
PROJECTOR ADDRESS 001
BAUDRATE [115200]
INTERFACE STANDARD [RS232]
RS422 TERMINATION [ON]
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-19
Available baud rates.
115200/57600/38400/19200/9600/4800/1200
9.7.3 Setting up the Interface Standard
Set up
The communication protocol for the communication between the projector and a computer can be set on RS232 or RS422. To set
up the desired protocol, handle as follow :
1. Push the cursor key ↑ or ↓ to highlight Interface Standard. (menu 9-20)
The actual interface standard will be displayed.
2. Press ENTER to toggle between RS232 and RS422.
Default : RS232
SERIAL COMMUNICATION
PROJECTOR ADDRESS 001
BAUDRATE [115200]
INTERFACE STANDARD [RS232]
RS422 TERMINATION [ON]
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 9-20
R5976654 SLM R12+ 09022004 97