R5911443 /11 UDM34
3.1 Pulse RCU, battery installation
About the batteries for the remote control
Batteries are no longer included in the packaging. It is up to the user to purchase the correct
batteries.
Use 2 AA size (alkaline) batteries in the remote control.
Before using your remote control, first install the batteries.
How to install
1. Push the battery cover tab with the fingernail a little backwards (1) and pull, at the same time, the cover
upwards (2).
Image 3–1
2. Insert the two AA size batteries, making sure the polarities match the + and - marks inside the battery
compartment.
Tip: Use alkaline batteries for optimum range and lifetime.
Image 3–2
3. Insert (1) both lower tabs of the battery cover in the gaps at the bottom of the remote control, and press (2)
the cover until it clicks in place.
Image 3–3
When replacing batteries, the broadcast address of the RCU will be reset to its default value '0'.
Pulse Remote Control Unit
To Next Page
Loading...
