89R5911443 /11 UDM
Take into account that while a laser ranging session is active, the projected image will be off. This to
have no interference between laser pointer and projected image.
Instead, a red border will be projected giving the outline of where the projected image should be.
How to measure the distance between projector and screen?
1. In the main menu, select Installation → Position → Laser ranging.
Image 8–3 Position menu, laser ranging
The Laser ranging menu is displayed.
Image 8–4 Example of the laser ranging menu
2. If you want to see the display of the laser range finder while performing a laser ranging session, enable the
Show on screen slider (blue is enabled, grey is disabled). While the Show on screen slider is enabled, the
measured distance will be projected alongside the laser dot and the red border.
Image 8–5 Example of projected image during laser ranging session with measurement on screen
3. For a single laser ranging calculation, press Single. This will continue the laser for 30 seconds straight.
or
If you want a continued laser ranging (e.g. when fine-tuning the position of the projector), press
Continuous.
GUI – Installation
To Next Page
Loading...
