Bard CompleteStat CS9B-THOA - Default Chapter; Table of Contents

Manual 2100-685
Page 2 of 18
TABLE OF CONTENTS
INSTALLATION ........................................................ 3
Display Options .................................................. 3
BASIC OPERATION ................................................. 5
Operational Overviews ......................................... 5
Setting Date/Time ............................................... 5
Scheduling ........................................................ 6
Adjusting Standby Conditions .............................. 7
Temporary Temperature Override .......................... 7
Adjusting Temporary Temperature Override Time
Length ........................................................... 7
Staging Delay ..................................................... 8
Remote Sensors ................................................. 8
Remote Indoor Air Temperature Sensor .............. 8
Outdoor Air Temperature Sensor ........................ 8
Remote Occupancy Sensor ............................... 9
Leaving Air Temperature Sensor ........................ 9
Dehumidification Setup ....................................... 9
Temperature Limits ........................................... 10
Heating/Cooling Loop Configuration .................... 10
Indoor Blower Settings ...................................... 11
Alarms Feature ................................................. 12
Security Settings .............................................. 13
Trend Logs ....................................................... 14
Restart ......................................................... 15
Restore Factory Settings .................................... 16
BACnet Communications ................................... 16
Advanced Time Settings for BACnet
Applications .................................................. 17
Temperature Sensor Calibration .......................... 18
FIGURES
Figure 1 CompleteStat Home Screen Features .... 3
Figure 2 User Interface (Display) Option ............. 3
Figure 3 Motion/Occupancy Sensor Detection
Range ................................................ 4
Figure 4 Setting Date/Time ............................... 6
Figure 5 Scheduling Options ............................. 6
Figure 6 Setting Time Periods ........................... 6
Figure 7 Adjusting Standby Conditions ............... 7
Figure 8 Cancelling Termporary Override ............ 7
Figure 9 Adjusting Temporary Override Time
Length ............................................... 8
Figure 10 Adjusting Remote Temperature Sensor .. 8
Figure 11 Adjusting Dehumidification Settings ... 10
Figure 12 Adjusting Temperature Limits ............. 10
Figure 13 Minimum Setpoint Differential &
Heating/Cooling Proportional Bands .... 11
Figure 14 Adjusting Heating/Cooling
Proportional Bands and Integers ......... 11
Figure 15 Adjusting Blower Settings .................. 11
Figure 16 Setting Up Space Temp Alarms .......... 12
Figure 17 Setting Up Humidity Alarms ............... 12
Figure 18 Viewing Internal Alarms ..................... 12
Figure 19 Alarm Details .................................... 13
Figure 20 Temporarily Deactivating Locking User
Interface .......................................... 13
Figure 21 Cancelling Locking User Interface ....... 13
Figure 22 Accessing/Programming Areas of
Security ........................................... 14
Figure 23 Accessing/Changing Passwords ........... 14
Figure 24
Accessing/Adjusting Inactivity Setting ... 14
Figure 25 Accessing Trend Logs ........................ 15
Figure 26 Programming New Trend Logs ............ 15
Figure 27 Programming New Trend Logs ............ 15
Figure 28 Initiating Restart ............................... 16
Figure 29 Setting Protocol and Parameters for
BACnet ............................................ 16
Figure 30 Accessing Device Instance, Name
and Location .................................... 17
TABLES
Table 1 UTC Offset Minutes Sample Time
Zones............................................... 18
NOTE
Screenshots shown in this manual reflect
default settings (when applicable).