Barnstead 30400 - Running the Program; Switching from Manual Mode to Automatic Mode; Verifying a Running Program

56 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

20

Verifying a Running Program

Press the SCROLL button until “StAt” is displayed.

The display will show “run” if the program is running, or

“oFF” if it is not running. Press the PAGE button to dis-

play Actual temperature.

SINGLE RAMP & DWELL CONTROLLER

Table of Contents

Table of Contents2
Safety Information4
- Alert Signals4
- Warnings4
General Specifications6
- Environmental Conditions6
- Declaration of Conformity7
Introduction8
- Intended Use8
- General Usage8
- Principles of Operation9
Unpacking10
Installation11
- Site Selection11
- Electrical Connections11
Operation, All Models12
- Power Switch12
- Cycle Light12
- Door Safety Switch12
Single Setpoint Models with OTP13
- Basic Operation13
- Buttons and Indicators13
- To View or Change the Setpoint14
- To View the Display Units14
- To View the % Output Power14
- Controller Parameters14
- Alarms15
- Sensor Break Protection16
- Over Temperature Protection (OTP)16
- Tuning17
Single Ramp and Dwell18
- Functions18
- Program Overview18
- Program Setup19
- Stopping the Program19
- Clearing the Flashing End19
- Running the Program20
- Switching from Manual Mode to Automatic Mode20
- Verifying a Running Program20
Segment & 4X16 Segment Programmable Models W/Otp21
- Basic Operation21
- To Change the Setpoint21
- To View the Display Units22
- To View the % Output Power22
- Buttons and Indicators22
- Controller Parameters23
- Alarms26
- Sensor Break Protection26
- Over Temperature Protection27
- To Operate the Controller as a Single Setpoint Controller27
- Programming Controller27
- Creating a New Program or Editing an Existing Program28
- Setting the Target Setpoint28
- Running a Program34
- Holding a Program35
- Cancelling a Program35
- Tuning Your Furnace35
- Gain Scheduling36
- Adaptive Tuning37
Installation and Operation of Air Control38
- Installation38
Furnace Loading39
Preventative Maintenance40
- General Cleaning Instructions40
Problem Solving41
Maintenance and Servicing44
- Warning44
- To Replace a Heating Element44
- To Replace a Platinel II Thermocouple45
- To Replace Solid State Relay46
- To Replace Door Switch (Microswitch)46
To Realign Door Strike47
To Replace Control Module48
- Single Setpoint Models49
- Segment Programmable Models with Otp49
Replacement Parts List49
Ordering Procedures51
Wiring Diagrams52
Two Year Limited Warranty56

Related product manuals

Barnstead F62730

Barnstead FB1300

Barnstead FB1415M

Preview: Barnstead FB1310M

Barnstead FB1310M

Barnstead 47900