Barnstead 30400 - Running a Program

34
8 SEGMENT & 4X16 SEGMENT PROGRAMMABLE MODELS W/OTP
Setting the Target Setpoint (4x16
Segment Programmable Models Only)
1. Press the PAGE button until you reach the
program list (ProG LiSt).
2. Press the SCROLL button until display reads,
“tGt.”
3. Press the UP or DOWN button to set the tar-
get setpoint temperature.
Running a Program (8
Segment Programmable
Models)
To run a program, press the RUN/HOLD button. (The
RUN light will illuminate.)
Running a Program (4x16
Segment Programmable
Models)
To run a program, press the RUN/HOLD button. (The
RUN light will illuminate) or:
1. Press the PAGE button until you reach the run
list (run LiSt).
2. Press the SCROLL button until display reads,
“PrG.”
3. Press the UP or DOWN button to select the
program number you want to run.
4. Press the RUN/HOLD button once to start the
program. (The RUN light will illuminate.)