Barnstead 30400 - Page 33

33
8 SEGMENT & 4X16 SEGMENT PROGRAMMABLE MODELS W/OTP
2. Press the SCROLL button until display reads,
“tYPE.”
3. Press the UP or DOWN button until display
reads, “cALL.”
4. Press the SCROLL button until display reads,
“PrG.n.”
5. Press the UP or DOWN button to select a pro-
gram number to be linked.
6. Press the SCROLL button until display reads,
“CYC.n.”
7. Press the UP or DOWN button to select the
number of cycles the linked program is to be
run.
End
To end or repeat a program:
1. Press the PAGE button until you reach the pro-
gram list (ProG LiSt).
2. Press the SCROLL button until display reads,
“tYPE.”
3. Press the UP or DOWN button until display
reads, “End.”
4. Press the SCROLL button until display reads,
“End.t.”
5. Press the UP or DOWN button to toggle
between “dwEll” (an indefinite dwell), “S OP”
(End Segment Output Power) and “rSET”
(reset).