1324D-1624D Owner’s Manual 8/29/18 Page 10 of 19
AXLE LOCK ADJUSTMENT
Cable should be adjusted so there is no slack in cable when upper lock lever is in the unlock
position. There should also be no tension on lock spring at lower lever.
Measure the position of the lower lock lever. Measure at the tip of the lever.
Put Axle lock lever in LOCK position.
Push down on handlebars and rotate trencher side-to-side to align the axle gears. The lower lock
lever should snap into its lock position.
Measure the position of the lower lock lever.
The movement of the lower lock lever should be 9/16" to 5/8" from the LOCK position to the
UNLOCK
position.
To Next Page
