Standard Features
Basler ace GigE 237
10.14.2 Saving a User Set
Saving the current active set into a user set in the camera’s non-volatile memory is a three step
process:
 Make changes to the camera’s settings until the camera is operating in a manner that you
would like to save.
îš„ Set the User Set Selector to User Set 1, User Set 2, or User Set 3.
îš„ Execute a User Set Save command to save the active set to the selected user set.
Saving an active set to a user set in the camera’s non-volatile memory will overwrite any parameters
that were previously saved in that user set.
You can set the User Set Selector and execute the User Set Save command from within your
application software by using the pylon API. The following code snippet illustrates using the API to
set the selector and execute the command:
Camera.UserSetSelector.SetValue( UserSetSelector_UserSet1 );
Camera.UserSetSave.Execute( );
For detailed information about using the pylon API, refer to the Basler pylon Programmer’s Guide
and API Reference.
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about the Basler pylon API and the pylon Viewer, see Section 3 on page 27.
To Next Page
Loading...
Need help?
General
