Physical Interface
44 Basler ace GigE
5.7.2 Characteristics
The camera is equipped with one physical input line designated as Input Line 1. The input line is
accessed via the 6-pin receptacle on the back of the camera.
As shown in Figure 23, the input line is opto-isolated. See the previous section for input voltages
and their significances. The absolute maximum input voltage is +30.0 VDC. The current draw for
each input line is between 5 mA and 15 mA.
Figure 24 shows an example of a typical circuit you can use to input a signal into the camera.
Fig. 23: Input Line Schematic
Fig. 24: Typical Input Circuit
To Next Page
Loading...
