Basler ace acA640-90gm - Page 83

Image Acquisition Control
Basler ace GigE 73
// Execute an acquisition start command to prepare for frame acquisition
Camera.AcquisitionStart.Execute( );
while ( ! finished )
{
// Execute a trigger software command to apply a software acquisition
// start trigger signal to the camera
Camera.TriggerSoftware.Execute( );
// Perform the required functions to parameterize the frame start
// trigger, to trigger 5 frame starts, and to retrieve 5 frames here
}
Camera.AcquisitionStop.Execute( );
// Note: as long as the Trigger Selector is set to Acquisition Start, executing
// a Trigger Software command will apply a software acquisition start trigger
// signal to the camera
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about the pylon API and the pylon Viewer, see Section 3 on page 27.