Configuring the Camera
Basler IP Camera 33
Motion Threshold - Sets a threshold for motion detection. If the number of changed pixels in the
current image is above the motion threshold and below the motion limit (see the next parameter),
then motion will be detected.
Motion Limit - Sets a limit for motion detection. If the number of changed pixels in the current
image is above the motion threshold (see the previous parameter) and below the motion limit, then
motion will be detected.
Alarm On Delay Milliseconds - Sets the amount of time (in milliseconds) that continuous motion
must be detected in order to declare a motion alarm condition.
Alarm Off Delay Milliseconds - Sets the amount of time (in milliseconds) that no motion must be
detected in order to end a motion alarm condition.
To Next Page
Loading...
Need help?
General
