Configuring the Camera
Basler IP Camera 49
Time Zone Description - Sets the time zone. See Table 2 on page 50 for a list of locations that
correspond to the time zone codes shown in the drop down list.
NTP - Enables or disables clock synchronization with an NTP server.
Off = NTP synchronization is disabled.
1 hour = NTP synchronization is enabled and updates occur once every 1 hour.
2 hours = NTP synchronization is enabled and updates occur once every 2 hours.
4 hours = NTP synchronization is enabled and updates occur once every 4 hour.s
12 hours = NTP synchronization is enabled and updates occur once every 12 hours.
24 hours = NTP synchronization is enabled and updates occur once every 24 hours.
Weekly = NTP synchronization is enabled and updates occur once per week.
NTP Server - Sets the IP Address or name of the NTP server to use when NTP synchronization
is enabled.
$I = display the hour as a decimal number using a 12-hour clock (i.e., from 01 to 12).
$m = display the month as a decimal number (i.e., from 01 to 12).
$M = display the minute as a decimal number.
$r = display the time in a.m. and p.m. notation.
$R = display the time in 24 hour notation.
$S = display the seconds as a decimal number.
$T = display the current time, same as entering $H:$M:$S.
$y = display the year without the century as a decimal number.
$Y = display the year as a decimal number.
$Z = display the time zone code if available.
To Next Page
Loading...
Need help?
General
