MNL-126509
April 4, 2013 Page 9
To change the user level press the “USER” button, select the desired user, and press “OK”. Then press the
button below the words “Enter Password” and press the password numbers on the keypad. After entering
the proper password press “ENT” on the keypad to enter the password. If the password is incorrect an
“Invalid Password” screen will pop up. The only option on the screen is to click “OK”. If the password is
accepted the screen will return to the login screen with the new user level shown.
2.1.2.2.6 Configuration
The Configuration button is used to setup the features that make the unit. There are a total of 4 pages in
this option. The first two pages consist of 8 features which a unit may have. The third page is used to set
the final pressure sensor limit. The fourth page is used to set the inlet pressure sensor limit. Similar to the
Parameter’s settings changing the Configuration settings will change how the unit operates so only users
2 & 3 are allowed to change them. Pressing the X button returns the user to the main menu screen.
Figure 2-6 Login Screens
To Next Page
Loading...
