Operation manual for BAUER RAINSTAR Series T32, T42 22
6.3.3 CHECKING THE SHUT-OFF
CAUTION ! Check if the final shut-off works properly before the first start-up and at the beginning of
every season.
10
Operate the shut-off frame on the retraction side of the RAINSTAR manually until system shut-off is
activated.
Thereby the gear shift lever must be shifted from the operating position and jump into position “0”. If this
is not the case, the shut-off system needs adjustment. See separate section in this manual for setting
instructions.
6.3.4 PE-PIPE PULL-OFF
11
Pick up the draw-out hook with the toolbar and pull off the pipe with the cart.
13
Symmetric or asymmetric wheel cart need not be lifted for pull-off.
Maximum pull-off speed: do not exceed 5 km/h!
CAUTION !
Do not stop the pull-off abruptly. Always slow down gradually for intermediate
stops in the field or at the end of the pull-off. Stop pipe pull-off when the white
marking line becomes visible on the reel – the end of the pipe is reached.
CAUTION !
If the PE-pipe has been exposed to the sun for a longer time or if its surface
temperature rises above 35 °C for some other reason, you must let water run
through the pipe for several minutes to cool it off before pull-off or retraction.
Before you put the machine into operation (turbine idle) with the cart
lowered and at least 1 meter of PE-pipe pulled off: move the gear shift
lever to “PE-pipe retraction”.
Help when changing gear
Reset the brake wheel with a screw driver.
To Next Page
Loading...
