Bauer RAINSTAR T32 Series - INSPECTION OF THE BAND BRAKE FOR RELEASE OF THE BAND BRAKE; SETTING THE GEARBOX SHUT-OFF

Operation manual for BAUER RAINSTAR Series T32, T42 63
11.6 INSPECTION OF THE BAND BRAKE FOR RELEASE OF THE BAND
BRAKE
Move shut-off lever (9) to the “Release” position.
In this position the band brake must be slightly lifted off the brake disc. This prevents the brake band from
sticking to the brake disc !
CAUTION!
The band brake may stick after a longer stand-still or after the winter period. It must
be loosened before putting the machine into operation again !!! Do this by shortly
turning the PTO shaft to the right and the left with the hand wheel. Non-observance
can cause the gear box to break !
11.7 SETTING THE GEARBOX SHUT-OFF
The speed compensating bar(13) is set at X mm distance to the reel (17) in shut-off position.
Set the locking lever (20) in position Y to the lift hook guidance ( see chart)
Screw down the screw (18) and lock with nut (19).
Switch the shut-off lever (9) into shut-off position.
Screw down the hex. nut (15) on the switch bar (16) to the bracket of the shut-off frame.
Lock the nut.