EasyManua.ls Logo

Bauer RAINSTAR T32 Series - OPERATING MODE II: LAYING DOWN THE PE-PIPE; SETTING OF TURBINE REGULATION

Bauer RAINSTAR T32 Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation manual for BAUER RAINSTAR Series T32, T42 23
6.4 OPERATING MODE II: LAYING DOWN THE PE-PIPE
Another method of putting down the PE-pipe on the ground is to unreel it while the machine is travelling over the
field. This method is mostly used when heavy soil makes it impossible to pull the cart across the field, or when the
field length is more than once or twice the PE-pipe length. Moreover, this laying down method can be done with
smaller tractors because no pulling forces are applied on the pipe.
Drive the RAINSTAR into the field allowing for the sprinkler’s distance of throw.
*) W = distance of throw
Lower the cart as described under operating mode I, “Lowering the cart” and slightly anchor it. Now
drive across the field with the RAINSTAR.
Carry out all other steps as described above.
Pipe guide (option)
It is possible to mount a pipe guide option which ensures that the PE-pipe is not laid down in a wavy line due to the
reel width. With this pipe guide the PE-pipe is laid down in a straight line according to the crop rows.
6.5 SETTING OF TURBINE REGULATION
13
NOTE!
Depending on the RAINSTAR’s flow-rate, the operating range of the
turbine regulation must be limited before start-up.
A
djust the setting bolt on the turbine which limits the toothed segment
of the regulation according to the chart on the opposite.
A wrong setting may block the turbine regulation!
The flow rate can be found in the perfor

Table of Contents

Related product manuals