Operation manual for BAUER RAINSTAR Series T32, T42 61
11.2 SETTING THE SHIFTING GATE
The shifting gate (8) must be adjusted to the shut-off point of the gearbox.
Procedure:
Move the shut-off lever (9) in position “PE – pipe retraction”
Actuate the inlet shaft (10) – the PTO shaft (11) will also start rotating“.
Shift the shut-off lever (9) slowly in position „0“.
.
The shut-off point is reached when the PTO shaft no longer rotates.
Set the shifting gate (8) in this position according to the drawing (2 mm / 0,08 inch) !
The spring (12) presses the shut-off lever (9) upward along the incline of the shifting gate and this way also
into the recess in the gearbox.
11.3 SETTING THE BAND BRAKE ON THE GEAR BOX
Place shut off lever into shut off position.
Pull the hexagon nuts (2) of the band brake, until the pull spring (12) has a length of A = 140 mm / 5,51
inch (2) secure the hexagon nuts
Pill the hexagon nut (3) until the spring(5) with B = 20 mm / 0,79 inch is biases, secure with nuts (4).
8
To Next Page
Loading...
