Operation manual for BAUER RAINSTAR Series T32, T42 35
7.7 OPERATION OF THE BAUER ECOSTAR 4300
Summary:
Pull off or lay down the PE – pipe
Connect water supply
Engage gearbox
ECOSTAR: make settings only in the standard menu:
Take over retraction speed from the last retraction or set again.
Press "START-RESET“
key
Activate pre-irrigation if required
Activate post-irrigation if required
Open water inlet
Irrigation runs automatically
FURTHER OPERATING INSTRUCTIONS
After a longer standstill the electronic system of the ECOSTAR 4300 is on standby.
Pulling off or laying down the PE – pipe activates the electronic system and the length of the pulled off or laid down
pipe is metered.
For display of laid out PE-pipe, press key Menu 1 x:
DISTANCE 123M
BATTERY 12.8V
CHARGE ON 0.231A
PRE- 0:45 POST- 0:45
To Next Page
Loading...
