BAUKER SBC30 - Grass trimmer spool replacement description; NOTE:; Brush Cutter Assembly and Disassembly; Pole Hedge Trimmer Shaft Assembly

EN-32
Grass trimmer spool replacement description(See Fig. B3-B6)
1) Hold the trimmer spool and pull out the cover.(B3)
2) Removing the spool from its housing.
3) Inserting 15mm of line into one of the holes in the upper section of the spool and wind
line in the direction of the arrows on the top of the spool .
3) Taking two lines of approximately 2.5m.
4) Rewinding the replacement grass trimmer line onto the spool in the same direction for
the upper and lower feeds as shown g B5.
5) Lining up the tails with the holes in the casing whilst still secured in the plastic notch on
each side.
6) Locating the spool over the spring and push it down into the housing once it is in place
you can release the line from the plastic notches bypulling on the line，This will free it and
enable the bump feed mechanism to operate.
7) Replacing the spool cover back on top if the housing and click it into place.
NOTE:
1.Use the nothches in the plastic to secure each of the lines as you wind them onto the
spool in image B6 and B7.
2. You will then end up with a spool as in image B8.
Brush Cutter Assembly and Disassembly (See Fig. C1-C2)
1. Put the backing ange (30) onto the spindle.
2. Fit the blade to the spindle. The rotational direction indicated on the guard and that
of the blade must agree. Ensure that the blade sits securely on the extruded ring on the
backing ange.
3. Put the locking ange (31) onto the blade. The pins must engage in the hole on the
backing ange.
4. Insert the spindle lock rod into the hole to lock the spindle. Screw the safety nut (32) by
use the spark plug wrench anti-clockwise. Remove the spindle lock rod.
5. Reverse the above order of steps to disassemble the brush cutter.
Pole Hedge Trimmer Shaft Assembly (See Fig. D1, D2)
1. Loosen the two bolts on the joint and then align the hole of the hedge trimmer shaft to
the bolt.
2. Insert the shaft and secure the connection with the bolts by using the hex key.
Pole Hedge Trimmer Shaft Adjustment (See Fig. E1, E2)
1. Depress the locking levers with one hand and hold them in position.
2. Rotate the shaft using the cutting bar adjustment handle with the other hand.