o Use the speed control button (2) to increase the
time in 1 minute intervals and the light control
button (3) to decrease the time in 1 minute
intervals. The maximum time that can be set is
“60:00”.
o When the required working time is shown on the
display, press the timer button (4) to confirm.
The remaining working time will be shown on the
display.
o You can then proceed to select a motor speed
using the speed control button (2).
o When the programmed working time has passed and the display
shows “00:00”, the range hood will automatically stop working.
If the hood lights have been turned on they will remain on
and will need to be switched off manually.
o If no buttons are pressed within 30 seconds, the backlight of the
display will automatically turn off.
IMPORTANT: The next time you go to set the timer function, after
pressing the timer button (4) if you don’t program a working time
within 5 seconds the timer will automatically set the working time from
the previous use.
16
To Next Page
Loading...
