8) If you are going to be using the hood in
extraction mode, you should fix the ducting
hose to the spigot.
o The electrical connection must
correspond to the electrical
requirement noted on the rating plate,
which is placed inside the range hood.
The appliance should now be connected
to the electrical supply. See page 21 -
22 for detailed information on the
electrical connection.
o Check that the appliance is operating correctly by selecting each
speed and switching the light bulbs on and off.
o Remove the hanging hook and then slide the lower chimney
section downwards, until it rests against the main body of the
range hood.
o Use a stainless steel cleaner and polish on the stainless steel
sections of the appliance.
o If you are using the appliance in recirculation mode, then you
should now fit the carbon filter. See the “Fitting the carbon filter”
section on pages 20 - 21.
Extraction mode or recirculation mode?
What is the difference between extraction and recirculation
modes?
To get optimum performance from your cooker, the air will be taken
out of the room via external ducting.
Unfortunately if you live in a flat or the hood is too far from an outside
wall, this may not be possible. The only alternative is to recirculate the
air.
In recirculation mode stale air is taken via the grease filter, and passed
through a charcoal filter for purification. The air then re-enters the
kitchen via an opening in the hood.
33
To Next Page
Loading...
